We don't have that issue in KSP with RT2, satellites are tracked as necessary. Geostationary is used in reality because it's easier to communicate with a satellite that never moves. The obvious solution if you either don't have the Communotron 32 yet, or if you only want to use three satellites is to lower the orbit. At 120 degrees of separation, that gives you a distance just over 6 Mm, which is longer than the communication range of any omnidirectional antenna in RT2. At 90 degrees of separation, that gives you a satellite to satellite distance of 4905553.3m, which is just under the 5 Mm range limit of the 32s. Here's a little geometry/trig for satellite setup in KSP for anyone that finds this thread at a later date (my math skills are a little rusty, so feel free to verify all of this):įour satellites at a geosync altitude of 2868750m above a 600000m sea level, this gives a distance of 3468750 m from the center. If you're low enough (geo-Kerbin Orbit is low enough) then consider using one of the omni-directional antennas for communicating to probes in Low Kerbin Orbit.Īctually, while I agree with this idea, geo-kerbin orbit is not low enough if you're doing three satellites (or using the Communotron 16s, but you already covered that). My bet would be that you don't have enough antennas on your commsat/vehicle, so when they're talking to your probe, they're not relaying to KSC. One end has "command", that is it has a link path to Mission Control.There is a clear line of sight between the two ends.(This step does not apply to omnidirectional antennas.) The antenna on each end is targeted on the other.The antenna on each end has the range to reach the other end. Any reason why, or at least an explanation of the mechanics?Five things are needed to form a link: Even though there is a connection with both the commsat and the ground vehicle, It still says no connection on the probe. I also have a small vehicle at the KSC with the Long range dish, the same as the one on the Duna probe. I have an SS-1(I think that's what it's called, the Duna dish one.) on the Duna probe, and the lesser range Mun dishes on the comms sat. I made a diagram to show my confusion(I cannot draw for my life though) Remotetech really confuses me, in the way of how satellites communicate with other, and their linkages, so if anyone is kind enough to answer my questions, that would be much appreciated.ġ. I could be doing it wrong, so don't take my word for it. I thought it was intended to target the closest receiving relay around that body, but I haven't seen it work that way. Honestly, I don't yet know what the benefit to pointing at a planetary body is. It took me some time to figure it out, too. Then you can use your dishes to point at probes and things. Putting these on your comm satellites will erase the need to point dishes at Mission Control and each other, so long as the satellites are within range (GKO is under 3Mm, so any antenna but the Comm-16 should work). If you're low enough (geo-Kerbin Orbit is low enough) then consider using one of the omni-directional antennas for communicating to probes in Low Kerbin Orbit. Mission Control is the only one you can just point at and have it work. Don't forget to point both dishes at each other (target the SS-1 to the comms sat, and the comms sat to the SS-1 on the Duna probe), otherwise they can't talk to each other.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |